Home > Products > Floor paint > Acrylic acid
Water-based single-component floor paint is also divided into two kinds of high light and light, product characteristics are as follows:
1, excellent hardness: in the case of high hardness, it can provide excellent wear resistance, impact resistance, and no deformation by hard objects.
2, good adhesion: with excellent adhesion, not easy to fall off.
3, drying speed: surface dry and practical fast, so the initial water resistance is good, good pollution resistance.
4, good chemical resistance: acid resistance, alkali resistance, water resistance.
5, cost-effective, simple construction
Construction description
Surface treatment: New steel - sandblasted to Sa2 standard, suitable workshop primer can be applied if temporary surface protection is required. For other surfaces - remove grease with cleaning agents, remove salt and other contaminants with high-pressure fresh water, and remove rust and loose coatings with sandblasting and power tools.
Construction conditions: Construction shall be carried out according to the recommended construction process, and ventilation shall be maintained during the drying period. Roller coating, brush coating, spraying, it is recommended to use high-pressure airless spraying, in order to obtain a uniform and good coating film, improve work efficiency. Before construction, it must be stirred evenly. If the viscosity is too large, 5%-10% of the weight of the original paint can be diluted to the construction viscosity as appropriate. In order to ensure the quality of the paint film, the relative humidity is >80%, or the temperature is <5℃, it is not recommended to construct.
| Property | Primer | Topcoat |
|---|---|---|
| State in Container | Uniform state with no hard lumps after mixing and stirring | |
| Viscosity | 90-100ku | |
| Fineness | <35um | <25um |
| Skinning | Does not skin when sealed and stored after use | |
| Applicability | Suitable for various application methods (roller coating, brushing, spraying) | |
| Flash Rust Inhibition | Normal | |
| Drying Time | At normal temperature and humidity | |
| Surface Dry | <20min | <30min |
| Hard Dry | <24h | <24h |
| Bend Test / mm | 1 | 1 |
| Pencil Hardness | B | HB |
| Impact Resistance / cm | >45 | >50 |
| Cross Cut Test / Grade | 1 | 0 |
| Gloss (60°) | 10/20 | >85 |
| Water Resistance (24h) | 24h | 48h |
| Salt Spray Resistance | >72h | >200h |
Copyright © 2024 Dayu Songying Chemical Co., Ltd.All rights reserved.Privacy policy
EN
